What You Need To Build Your Own Solar System

Build Your Own Solar System

 

One of the biggest arguments to solar energy has little to do with how effective they are
but is more related to the cost. When purchasing the system from a solar energy company,
the cost of a good solar system could quickly become quite expensive. In fact, in many
cases the cost of the system was more than the savings on their electric bill.
However, depending on how much power you need and how much skill you have there are
quite a few that have learned to install a DIY solar system for as little as $1,000. It will
take an investment in your time and the necessary skills, but it is possible to get your
system up and running in a weekend without paying exorbitant fees to greedy
corporations.
To get started, there are four basic components to every solar power system.

Solar Panels
Smaller systems will only need a single solar panel to get started. The panels you choose
should come equipped with a junction box and the necessary wires and conduit for
installation. You ’ ll also need screws, nuts, and bolts for easy mounting.
A single panel runs around $140.00 and up give or take, so if you ’ re working on a tight
budget, you can buy them one at a time until you have the number you need. Before you
start purchasing your solar panels, you need to know how much power you wish to
generate. This is called calculating your load.
The size of the panel you choose will be determined in terms of Watts, which refer to the
output each panel can generate. A 100-Watt panel will generate 100 Watt-hours of
electricity each hour. The amount of wattage produced will also have an impact on the
physical size of the panel. You will have to find a panel that will physically fit in the area
you plan to install it and still give you enough energy you want to generate.
There is however, a wide range of solar panels to choose from so make sure that you get
one that is best suited for the amount of power you want to generate because you ’ re
going to be living with your decision for a very, very, very long time. There are three
factors to consider when choosing solar panels.
There are 3 levels of quality to consider in solar panels. Tier 1 is considered to be top
quality where every stage of the manufacturing is tightly controlled. Tier 2 panels are
considered well made but are built with less control.
There are several Tier 2 panels that can perform well but were not monitored well during
the construction phase. Tier 3 panels are basically components that have been assembled
by third parties with practically no specified guidelines. There is no way of knowing the
quality of materials used in the production of these panels and since they are usually put
together by human hands, quality can vary from panel to the next.
You also want to check the warranty to determine the longevity of your panels. Reputable
manufacturers will guarantee their panels for up to 25 years.

 

The Charge Controller
The Charge Controller is responsible for adjusting the amount of energy that flows into the battery. It has a small LED light that shows constantly displays how much charge the batter holds at any given time.
Some models have a red, yellow, or green light indicating how much of a charge the
battery is holding. If the light is green, everything is good but if it flashes yellow, you need
to cut back on power, and if it flashes red, it is almost out of electricity.

diy-solar

The Battery
Choosing the right battery is also important. As of now, there is no battery specifically
designed for storing solar power so choosing one that can be charged up, drained,
recharged, and drained (called cycles) again over years is not always easy. There are quite
a few to choose from but each has its own drawbacks. Here are some comments on just a
few.
It is important to choose the right battery because upgrading your battery if it ’ s not
storing enough power can not only be complicated but also expensive. It is best to make
the decision right the first time.
Capacity: Battery capacity is measured in amp hours. A battery will produce 100
amps/hour before being completely drained. The higher the amp hour, the longer the
battery will last before needing to be recharged.
You will need to convert the amp hours of a battery to wattage. This is done by
multiplying the AH by the voltage.
Battery Amp Hours X Battery Voltage = Total Watt Hours
Size: Once you know the wattage a battery can produce you can determine how much
energy you will need. Look at all of your appliances and check the wattage stickers. To
calculate exactly how much energy your solar system will need to produce simply total
how much energy consumption you will need per hour for each appliance and total all of
the figures together.
So, if you have a TV that requires 20W/hour and you plan to have it on for 2 hours/day,
the battery will need to supply 40WH/day. Once you ’ ve done that for all the electrical
appliances you can determine the battery capacity you will need.
Other factors to consider are how much sunshine you get in your region, how much time
will you have without sunshine, other power sources you may also be using (wind, hydro,
etc.), and the availability of your backup system.
The 8D Battery: This is a large battery that can hold a lot of energybut for use in a solar
system, it doesn ’ t hold consistent cycling over extended periods of time. These batteries
under solar power will usually burn out in less than a year.
Dual Purpose Gel Cells: Probably the favored option for storing solar power. They can last
for quite a few years before needing to be replaced. They have one negative; they cannot
stand overcharging.
Once they have been overcharged, their usefulness is spent and they will likely need
replacing. However, gel cells require no venting and can be placed in any position without
impacting their performance. So, they can be laid on their sides, upright, or even upside
down if needed.
6 Volt Batteries: Truly deep cycle batteries that can perform well for quite a few recharges.
These are often used in golf carts because they can be reloaded many times. The challenge
with 6 Volt batteries is that they can be quickly discharged.

diy-solar

Inverter
Lastly, you will need an inverter. This is the instrument that will convert the power stored into AC power. You can find inverters in a wide range that will suit a number of different systems. Just like with batteries, there are several factors to keep in mind when choosing an inverter.
Aside from knowing the wattage and the amperage needed each day, you also need to plan
for power surges (or the maximum amount of energy the inverter will need to produce
during peak times).
Choose your inverter based on their size ratings. They will have two separate ratings.
Their surge rating specifies how much energy it can convert during peak periods and for
how long and a continuous rating, indicating how much energy it will produce on a
continuous basis.

Click Below for a step-by-step video course on how to be energy independent

diyhomeenergybox